Twin Handle Kitchen Faucets or taps have two handles, valves controlled by different handles. The handle on the left controls the opening of the hot water, and the other one the right controls the opening of the cold water.
The length of the lead-in wire is determined by the thickness of the material and the cutting method employed. In general, the length of the lead is lengthened as the thickness increases . When cutting the CNC cutting machine steel plate, in order to ensure the integrity of the cutting part, the starting point of the cutting can not be on the contour line of the part. For the outer contour part, it should be fired outside the part contour. For the inner contour part, it should be inside the part contour. In the event of a fire, we put a fire on the extra cut line on the contour of the part, called the lead-in line.
When the cut remains as an outer contour, the lead-in position should be within the contour; when the cut-retained portion is the inner contour, the opposite is true. In addition, in the design of the lead-in, the loss of the whole board should be taken into account, and the position should be considered as far as possible to consider the edge and the top angle to reduce the material loss. The length of the lead-in wire varies depending on the material, thickness and cutting energy of the cut part, but the overall control can be in the range of 1-10 mm . As for the position design of the lead-in line, it will vary depending on the part of the cut .
CNC Equipment Co., Ltd. Shanxi Hua Heng arrangements will explain in detail for everyone under CNC cutting machine inlet should note the following:
1. Straight leads, in actual and various, straight leads are most commonly used, but it is easy to leave a dent and small tail at the beginning and end of cutting. When the inner cavity is square, the lead wire is generally cut from a certain angle, and the circular inner cavity generally has no requirement.
2 , round lead, if a higher quality cutting joint is required, it is best to use a round lead.
3. Arrangement of the lead when cutting the shape of the workpiece When cutting the shape, straight lead is generally used.
4. Arrangement of the lead-in wire when cutting the inner cavity of the workpiece.
     Â
5 , design introduction of the line, should also minimize material waste, sometimes with nesting to consider.
6. The lead-in wire should be as short as possible without affecting the perforation and cutting. The direction of introduction should be as consistent as possible with the cutting machine. The slag splashed during the perforation should not fly to the cutter, but fly in the opposite direction to the start of the cutter.
          Â
According to the needs of welding or machining, the user can choose a small amount of over-burning, leaving a small tail, or an approximately smooth cutting point to introduce the lead-out method. In the introduction of the lead-out compensation surface, a few CNC cutting machine systems currently provide similar functions. Taking the SH2200 series CNC system as an example, the introduced lead-out line compensation method can effectively solve the quality problem of the burnt-out scar at the cut-off point.
Twin Handle Kitchen Faucets,Mixer Tap Faucet For Kitchen,Gunmetal Kitchen Faucet,Dual Handle Kitchen Faucet
Kaiping Jenor Sanitary Ware Co., Ltd , https://www.jmjenorsanitary.com