People's living standards have improved, so there have been improvements in the use of household tools, so some household appliances are also relatively common, such as our washing machine, almost every family will install a washing machine, it It brings a lot of convenience to our life, so how to do the washing machine faucet leak ? How to pick up the washing machine faucet? The small series of the decoration home network below will introduce it to everyone. First, how to do the washing machine faucet leaking 1. The ordinary faucet cannot be connected to the washing machine water pipe. It is necessary to make sure that the faucet is a faucet dedicated to the washing machine water pipe. The special washing machine faucet is not the same as the ordinary faucet, because the front end of the joint of the special washing machine faucet has a groove. Some faucets have a screw at the front end, which can be connected to a groove to be converted into a washing machine faucet. This groove shop is available for sale. 2. It may be that the triangular seal of the gland is worn out and the gap in the lower part of the tap is leaking. In this case, the screw can be loosened to remove the hoe, then the cap is loosened, and then the inner triangular seal of the gland is removed and replaced with a new one. In addition, the looseness of the cap nut may also cause water leakage at the joint, and the cap nut can be retightened or replaced with a new U-ring. 3. The washing machine faucet and the water pipe are not tight. It is the drawback of many washing machine faucets. The solution is to strictly control the size when purchasing the faucet, or bring the water pipe to the site for connection. Be sure to find the faucet that is tightly connected. If the washing machine faucet has been bought back, it is not tight, you can only use the raw material tape wrapped around the groove of the faucet, and then connect the water pipe, so that there will be no water leakage. Second, how to pick up the washing machine faucet 1. Take out the automatic washing machine inlet pipe fittings, find the end with the inlet pipe joint, and then press the slider to separate the inlet pipe joint from the inlet pipe. Loosen the four screws on the inlet connector evenly until the faucet can be inserted. If the faucet is too large, you can remove the bushing. Then loosen the plastic interface nut to expose approximately 3-4 turns of thread. 2. Put the inlet pipe joint on the faucet, attach the black washer in the joint to the faucet, then tighten the screw with a screwdriver, tighten the plastic interface nut, tighten until it leaks, and then connect the inlet pipe and the inlet pipe. Connector. Connect the other end of the inlet pipe to the water inlet of the fully automatic washing machine, tighten the plastic nut, and install it. 3, washing machine faucet belongs to the tap (collectively referred to or referred to as) one of the washing machine special faucet, the difference is that the outlet of the special faucet can directly set the washing machine inlet pipe, you can use the washing machine faucet as a tap, if you use the tap Can not pick up the washing machine inlet pipe. The washing machine is a must-have appliance in the family. With it, we can save a lot of things, so the washing machine gives us a lot of help. Then how to do the washing machine faucet leaks, how do you pick up the small series? I understand that, if you still want to know more about decoration, please continue to pay attention to the decoration home Internet cafe. More related wonderful reading: Washing machine faucet to buy washing machine faucet leaking reason Organic Amide,Docosanamide Powder,Amide As Emulsifier,Rubber Auxiliary Agents Sichuan Tianyu Oleochemical Co., Ltd , https://www.sclthoil.com
