The use of mosaic tiles in home renovation is both generous and personal, whether it is simple or collage colors have their own charm. So how do you attach a mosaic tile ? Here's a look at mosaic tile with Xiaobian! Mosaic decoration is a meticulous job, and it must be handled well during the paving process. The process of paving includes: gluing on tiles, paving tiles, checking paving and staggering. 1, brush glue Brush glue is the key to laying a good mosaic, ready to mix according to the proportion of strong tile adhesive, with a plastering knife tile adhesive on the wall, pay attention to the amount of smear can not be too much. First apply the glue on the wall surface, and then use a smooth trowel to smear the glue evenly. Generally, the thickness of the glue is about 20mm. Note that the agitated mosaic adhesive cement should be controlled within 2-3 hours depending on weather conditions. 2, tile After brushing the glue, align the mosaic with the gap in the alignment of the drawings, use a plastering knife or a putty knife to hold the mosaic tightly, or use a flat thick plank to padded on the surface of the mosaic and tap it evenly with a rubber hammer to ensure firm attachment. Since each small piece of mosaic is fixed with a net, the glue is infiltrated into each fine grid after being attached to the wall to achieve a fixed effect. 3, check the paving situation After paving a certain range of mosaics, check the condition of the paving. First, the gap between bricks and bricks must be determined to be a uniform width. This will depend on the use of small gray shovels to adjust the mortar joints. This is a process that most requires patience in the mosaic process, but during the paving work process Is the most important link. In addition, the mosaic of the paved tiles was checked and leaked, and the missing small mosaics were filled. 4, pointing After the inspection is completed, after the water is properly dry and has an initial strength, start the jointing process, prepare the required joint sealant, and pour the joint sealant into the mosaic gap with a plastering knife. Note that the area of ​​the squeegee does not exceed 2 square meters. The sealant is evenly applied to the mosaic surface, ensuring that all mortar joints are completely filled and there is no excess residue. Careful attention should be paid when caulking, 20-25 minutes after caulking with a damp cloth gently wipe dry the mosaic surface of the caulking agent. Editor's summary: The above is a detailed consultation on how to attach a mosaic tile. I hope to help you. More information on how to paste mosaic tiles is on this site. Stay tuned. Mosaic mosaic decorative tile mosaic tile glue fan s
Food Grade Sea Salt is including Iodized Salt and Non-iodized Salt, mainly used for condiments and pickled foods.
This all-purpose, easy-to-store (plain or iodized) salt is intended for general baking, cooking, canning, pickling, as well as for use at the table. The uniformly shaped salt crystals make Plain Salt and Iodized Salt your ideal kitchen salt where ingredient measurements are critical.
Food Grade Sea Salt, Iodized Salt, Non-iodized Salt Weifang Xinchang Chemical Co.,Ltd , http://www.xinchangchem.com
