Cast Iron Pipe,Epoxy Coating Cast Iron Pipe,En877 Cast Iron Pipe Wanlei Steel Pipe Co., Ltd. , http://www.tjsteelpipes.com
1. Card jamming On the passage of the coil card, the side door can be opened and handed in to scroll the card motor. If the card cannot be removed before or after the roll, the card may have been peeled or deformed. In this case, it is best to seal the road and open the front door. If the computer still shows a card failure after removal, restart the card.
2. Watch the computer display the number of card machine failure, to facilitate its handling. First open the side door to see if the card is stuck. If it is not possible to remove the card holder, push the card backwards and then raise it.
3. When the current car does not leave the rear coil, the next car may not get the card. Sometimes when the car leaves the rear coil, the next car immediately presses the button, and the light of the card exit port is blinking. You need to wait for the lamp to go out and then press the key to take the card.
4. Listen to the card circuit board to see if there is an unusual "beep" sound and find out the related problems. And for power off replacement processing.
5. Lifting over and over to cause abnormal sound, can be powered off, use a flat screwdriver to reach the hole to adjust the level. Press lift button test again, if not, please replace the lifting drive plate when power is turned off. 6. When the car travels to the front coil, and hear the “button took out the card tone†can not get the card, first watch the bayonet LED is not Strobe (stroboflash normal, flash shows card ticket), and then look at the computer shows whether the four workstation failure, or card communication failures and so on. If all are normal, ask the driver to restart the IPC or restart the IPC.
Second, daily maintenance
1. Always remind the card collector that the bad card recovery box in the left door of the card machine must be remembered if it is not pushed out after it is removed. It will cause the bad card to be lost when it is recycled.
2. After several months of observation and using the clip to raise it, gently push it backwards and forwards and push it down if it is loose. This can sometimes result in the inability to issue cards. If this happens, contact the technician to deal with it.
Third, the lane FAQ
1. After the driver removes the card, the railing is not lifted. You can check whether the computer information indicates the vehicle pick-up process. If so, push the pole open to allow the driver to pass. On the contrary, the pole did not fall and the iron plate could be used to test the rear coil.
2 If there is no fault in the computer's display card, it may not be sensed when the vehicle is pressed to the coil. You can see whether the coil module light is on (the light proves that it is sensed) and hear the “button took the card†if it is not lit. Rewind the coil, or reset the coil module.
3. Check whether the word "Waiting for the driver to take the card" is displayed in the lower right corner of the computer. If it is not possible that the software is stuck, restart the charging software with the keyboard. In addition, the right side of the data can be observed by the driver over the car information. Without a step, the problem is better
Automatic Card Issuer Common Faults and Routine Maintenance
First, the card machine fault has the following reference